Routing

Hi All,Customer is curently having office in mumbai and kolkata connected over point to point link. As well as a backup connectivity on internet using site-to-site VPN.At mumbai office there is internet connectivity as well as at kolkata office.Requi...

There are alot of products out there that state they are dual WAN products. Does Cisco offer a solution that is dual WAN and can offer load balancing and failover? I have many routers and PIXs

i have some peculiar requirements to select some cisco devices, can i expect some help here.

We will have 4mbps link. do 2821 or 2851 Router support 4 mbps link or should we have higher router?

We have 7 location, All locations We wants to connect throught lease line upto 512kbps.For center site we select these products.CISCO2811, WIC-2T, CAB-SS-V35MT.This is right selection na if any thing wroung pls let me know soon. regds

Dear Sir,Can you please tell me, Is this possible that i take un-channelized E3 from PSTN and convert it into different channels. or i only use the same un-channelized card with DSU.regards

hii need advice on setting up a converged data and voice network.The wan uses 2M Leased lines.The leased lines were originally used for voice only while data was running on a Frame-relay circuit of 128k.Since the voice network seemed to be underutili...

Hi thereIs there a command to show the number of memory slots that are occupied in the RSP4 of a 7513?TIA

Dear experts, I WIll give total setup Iam having 3 bran ches in hyderabad i tool mlln point to point connectivity for viedeo conference. 1)main office iam using 2811 router using rip iam accessing the remote user. 2)branch-banjarahills here iam using...

Why my pppoe connection always disconect? bellow is my config and debug :ip sla monitor 1 type dns target-addr http://www.google.com name-server 202.188.0.133 timeout 2000 threshold 4 frequency 15ip sla monitor schedule 1 life forever start-time nowv...

Frame Relay - Unable to ping localframe relay interfaces and in some case remote frame relay interfaces as well, but LAN to LAN traffic through Frame Relay cloud is fine. I used to know the reason on why this happens but I have forgotten.I think loca...

I was told by AT&T that I needed to make sure my router was set to AutoLearn and Annex-D. What exactly is this and how do I configure it? I'm using a 2811 with a T1 CSU/DSU WIC.Thanks.

Hi,We have a 2600 Router that uses ATM and is connected via T1 line to a Fore ASX1200 at our main site. We experience terrible slowdowns during the day and downloads will often time out. We've tried unplugging everything and just plugging the route...