Routing

guys i have cisco 2620 router with 16MB flash and 64 MB RAM.........now ihave put cisco NM 2V and VIV 2fxs card......i want to simulate alanloge calls between two routers (the other one is 2811) so can some one please advise me what would be the best...

Hello All,On my internet router I have 2 Fa interfaces and 1 serial. Fa0/0 is connected to my internal network. S0/0/0 is connected to one ISP. Fa0/1 is conencted to a second ISP. I would like all my HTTP traffic (Web Browsing) to go through Fa0/1 to...

Good Day!We have a client PABX that needs to connect to 3662 voice gateway via T1 CAShere's the connection details:T1 CAS Specs:B8ZS /ESF/CAS/DTMFCall Manager 4.013662 config: controller T1 1/0 framing esf linecode b8zs pri-group timeslots 1-24 contr...

Hi all,Currently, I am trying to design a network with 1) internet access, and 2) a point to point link with another location. My ISP is going to handle the point to point and internet connection over wireless equipment (the new building is in a non...

Hi,I want to get some priority queueing rolling on my router. I already have some in place that works fine, but I want to throw packets with a port destination of 5060 (sip) to the top of the heap. Here is what I have so far:interface Serial1/0 ip ...

Hi all,I am in the process of upgrading the rommon (bootstrap) of a Cisco 2621 router, the only method i've reached is to go to the rommon mode and do the following:> rommon 4 > IP_ADDRESS=<ip_address_for_the_local_router>> rommon 5 > IP_SUBNET_MASK=...

i would like for some one would tell me what is the packet thruput of the npe-g2 and the difrence with the npe-400

Hi,I'm looking to replace an old 7204 router (NPE-150) with something more up to date. The machine is beginning to run out of memory and that specific NPE is maxed out on the RAM (128MB). I'm not crazy about having to spend 30,000 on a 7206VXR with...

What are the advantage of using MPLS Vs. Point to Point circuits? I know MPLS offers a Mesh. Are there any other major advantages of using MPLS. Is QoS better on a MPLS vs Point to Point? It appears to be no difference to me because QoS would just...

Hi,I am using Cisco 7206VXR, NPE-G1 engine. However, I am getting the following: %BCM-4-ECC_L2CACHE: Corrected ECC from L2 cacheCan I know what did it mean? Can I know where to check this log?

I have a problem decribed here:ROUTER CISCO 1801: config: interface BRI0 no ip address encapsulation ppp dialer pool-member 1 isdn switch-type basic-net3 isdn tei-negotiation first-call isdn point-to-point-setup isdn spid1 xxxxxxxxxx interface Dialer...

I'm replacing a Cisco 4500 running IOS 12.1(22c) by a Cisco 2801 with IOS 12.4(1c) with (as much as possible) same configuration. All works fine except a GRE-tunnel that is traversing the router.Debug of 4500 that works correct:Mar 14 21:04:47.514: N...