Routing

hi,i have an isdn pri interface, which should NOT generate any trap if it goes up or down - this is the config:interface Serial3/0:15 no ip address encapsulation ppp load-interval 30 timeout absolute 600 0 dialer pool-member 215 no snmp trap link-sta...

Hi,I have a 2 Mbps ATM connection with an RJ45 interface. i am going to be using a VWIC2-2MFT-T1/E1 as the interface card but wondered if i need a AIM-ATM or can teh ATM encaps be done in software like it is with a DSL ?Cheers

PPP LFI (link fragmentation and interleaving) over L2TPv3 - is it possible? Could anybody implement this with Cisco routers? The problem is the following. We have a central office with Cisco3660 and some remote offices with, say, Cisco 871s. The remo...

Dear All, I was reading my NAT Design Paper, because I am going to Implement NAT in My Company.Now, I want to ask you for only the Process of Static NAT , to allow External Users ? on internet side ? to ? access a specific server inside my LAN.Which ...

% Hostname "SNST-7S-3640-W-R " is not a legal LAT node name, Using "CISCO_029040"

Hi everyone:This is my first time posting. I have a customer that wants to connect same subnet via two different location using 10.10.10.x /24 for example, due to restrictions. Below is how the network would look. I read the document below about I...

Hi there. First than all, I'm a newbie on cisco. Here's my problem. I have a cisco 1801 with FastEthernet0 connected to a wireless bridge (WAN) and FastEthernet 6 connected to a layer 2 switch (LAN). Router's WAN IP address is 192.168.100.44 and LAN ...

What will cause to a Supervisor engine to become faulty . In my Cat 5505 everything is working ok but when I issue sh module I'll get thisMod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ...

Just want to verify two things about MPLS:1. MPLS P (core) routers only require only "mpls ip" enabled under interface config. IP CEF is also required ? There is NO other special MPLS config required on P routers ?2. Under bgp process "address-family...

Hi,i have configured un ISDN backup connections to un CDN.I have not traffics DDR because the CDN connections is UP, but when i do:show isdn status the output is -------------------------------------------------------------------------------- ...

I recall reading or hearing somewhere that there was a practical restriction, or at least a best practice, regarding priority queueing for voice across WAN links.I thought that you cannot, or should not, build QOS parameters to allocate >20% of the W...

I am trying to set up an 877 in unnumbered mode. The DSL line comes up fine and from the router console I can ping the outside just fine, but nothing on the inside will pass through. I am thinking it might be an ACL that must be implemented but can...

I have a remote user who lives in an area with poor broadband service and a decision has been made to install a T1 in their house. Normally for remote branches we've been using Cisco 2811 routers to terminate the T1s and manage the VPN tunnels.The pr...

Hi I am current having difficulty with a section of CAD operators who need to download CAD drawings all day long (on a 512k connection). I have applied the following ACL and Limits on Serial0.01: rate-limit input access-group 101 512000 24000 32000 c...