Routing

I've gone as far as configuring MLP using two 2048kbps serial links. In my setup, s0/1 and s0/2 are members of Multilink 2. The problem is, s0/2 goes protocol up and down every several seconds to a minute. My understanding of MLP is that the flapping...

We are looking to move away from a single area ospf design to multiple areas. Right now we are using just area 1. We would also like to do better summarization, authentication, etc.I was thinking we could make the transition smoother by running two...

Ok - here is the setup.Cisco 7204.Ethernet 1/0 - private LAN interface 10.42.111.254 255.255.240.0Ethernet 1/2 - Connection to parent company - 10.220.17.250 255.255.255.224FastEthernet 3/0 - connection to internet 67.X.X.82 and 84 255.255.255.240Hav...

Hi,Can anyone help me how to configure a modem dsl and link it to a cisco router 2811. Please help me. God bless.

I am getting the slot alarm on UXM card.I checked dspslotalms , I can see only Minor Alarm on Slot.If I clear that Alaram clrcdstats , within one min. i again see Minor Alarm.What can I do for that.PLz suggest me.

This is a lab scenario that closely depicts a [not yet] production solution. The desired result is to leverage an existing WAN router with available interfaces rather than use a seperate WAN router for the ISP edge but to send internet traffic throu...

Hi,Hopefully a simple question to answer,Using the 1800 series router is it possible to Traffic shape inbound & outbound traffic based on a particular TCP port.ExampleRestrict SMTP traffic (Port 25) in & out to 25% of the bandwidth available on the W...

We don't run IS-IS in my organization and I am kind of surprised that the BCSI-CCNP exams seems to have quite a bit of IS-IS content there (?)Anyone can recommend labs or books which I can use showing labs on IS-IS ? I have (3) 2610's to practice.

Hello Guys,I am in a little trouble here, 2 questions ! please give away your comments:scenario:In a multisite network enviornment, SITE-A is having multi-service providers and making GRE tunnels with Site-B & Site-C.Site-A is running backbone Area 0...

Hi,Is any good IPV6 document available online

Hello,My first time setting up such a WAN configuration, appreciate any/all advice.The requirement is to have redundant T1 links (min of 256k for data) between a site in N-A and a site in Europe. No need to aggregate, just to have redundant paths in...

Greetings,I will be replacing my 3660 router(all serial ports) with the 3800 router(controller T1 ports). Can bandwidth, ip address, and ecapsulation be configured on the controller? Thank you.

Hi,I have 2lines on my router : ADSL and T1.I want that when the T1 lost connection the backup lines ADSL start.I have SDM v2.3.2.And i don't know how do this backup.In advance thanks !!this is urgently Please