Routing

Dear expertsI have a 2501, today, it bootup again and again. as the following information:System Bootstrap, Version 11.0(10c), SOFTWARECopyright (c) 1986-1996 by cisco Systems2500 processor with 16384 Kbytes of main memorySystem Bootstrap, Version 11...

I am thinking of using a 1841 at an Muli-tenant building and offer different tiers of service. Can this router limit bandwidth ingress and egress per ip address?

What is the max upstream speed of an ADSL Cisco 837? I think the downstream is 8mb.

We have a pair of IGX 8420s connected over a NTM E1 trunk. Over this trunk several 24-channel UVM connections are routed. Each 24-channel connection uses up approx 700packets/sec using g729ar8v compression. We are trying to switch the E1 trunk to a U...

Is it possible to connect 2 Routers Back to back using HSSI using CAB=HSI1 instead of CAB=HNUL. The Interface card on each router is a PA-H. Any body has any ideas ?

I have location A and location B and C connecting to location A using serial interfaces with frame-relay encapsulation and GRE Tunnel configure on the interfaces. I am using EIGRP as routing protocol. I also configured the HSRP on location B and C to...

Mrs, I have a problem with my 3660 IOS 12.3(13B), I configure a module of serial 4T (4 serial) with 4 E1, it's work fine, but when I configure other serial with WIC 2T I have a lot of errors and the WIC Interfaces are down. The interfaces doesn't co...

Layer 1 is activeLayer 2 is activeLayer 3 is active but calls are getting disconnected.pls get me the info.regardsBabu

I have ip local pool configured on router, in order for this range to be reached, I added reverse-route within crypto dyn-map. In addition, I created a static route for this range which then I re-distributed into ospf. The problem is that everytime a...

Dear,I have ten MWR 1941-DC router.I am using these router for E1 link. But I am facing link trouble( this router is configured redudency--y cable).Can you tell whether these router is feasible for E1 link ( data connectivity)or not?

Hello all.I have a 802.1q Trunk (3Vlans) on the c2621xm FE0/1.On one of those vlans (vlan100), I have a pppoe connexion client.I try to create this connexion but I think it's impossible :(this is a part of my conf :bba-group pppoe PPP_VLAN100 virtual...

Please, i 'm looking a complete configuration of docsis cpe configurator.Any suggest will be appreciated.Best regards.

Hi,I'm new to Cisco, just got a Cisco 878 Router and want to sort out QoS for my Voip Phones. As i'm new, went to SDM and when I cliked QoS it said i need a IOS upgrade! They market this router as QoS ready and i'm now trying to source this IOS upgra...