Routing

Hi alli have small confusion of buying the modulesi have 7200 VXR with NPE 300at this moment my telco giving me all G 703 with Modem converter to V.35now they planning to shift E1'sand factional E1 for less than 2MBlike 64/128/256 like...so iam confu...

Has anybody any experience of tunneling Decnet from a large number of nodes to a data centre over an IP only network?

i set nat overload on router 2801, sometime cpu can reach 100%.How can i limit process nat and reduce cpu used ?Best regards.

I have a 837 it was running k9o3y6 123-14.T2 this did connect ok thru the ATM interface, but started getting continual tracebacks, so up graded to 123-14.T5 but now cannot get a connection, the atm interface is down and down, The ADSL RXD and TXD are...

i m network engineer in an ISP. i want to keep track of the internet traffic of each ip and different applications used by that ip, for that i choose etherreal software. from a etherreal forum someone told me to mirror a router or switch interface.ca...

Hi,I've:ip route 192.168.1.2 255.255.255.255 192.168.2.100where 192.168.2.100 is another cisco router.I need:set routingip route 192.168.1.2 255.255.255.255 192.168.2.100together with something like:ip route 192.168.1.2 port 22 255.255.255.255 192.16...

getting error "line protcol is down" and port light (gbic 0/1) goes intermittently from orange to green and then eventually shuts down (above message)....any ideas, ...and how do I turn the port back on without resetting the switch?Thx.

hi i would like to ask a simple question.....can i config ospf on 2500 router.....is there any specific needs for routing protocols like for example.....certain amount of flash or ram or hardware...thanking in advance

Dear All,We are having Cisco 12012 Router with ios 12.0(28)S5POS line card in slot1 is not showing active.KUIX_1#show diags 1SLOT 1 (RP/LC 1 ): 4 Port Packet Over SONET OC-3c/STM-1 Single Mode MAIN: type 33, 800-2389-02 rev M0 Deviation: 0 ...

Hi,We've a network consisting of multiple areas. In one of the area, the spf algorithm is getting exceuted quite frequently. On an average spf is getting executed once in every 5 seconds. What could be the issue. There is no link failure.In this are...

I am requesting assitance in putting together the following IGX BOX.I have all the equipment available, but being totally unfamiliar with the IGX boxes, I am looking for someone to assist me with putting this box together.According to the client the ...

Is there any way, NetPro can host some TechTalks about the direction service providers are implementing for its customers in regards to the transition from IPv4 to IPv6? There has NOT that much information (e.g. books/white papers) in regards to IPv...