Routing

with help from a new friend. I recovered my cisco image but i had to remove the wic in order for the image to transfer without errors stating that memory is insufficient. but after i took the card out image loaded no problem and i was in user mode, b...

We have a 128 frame relay link - cir 64.Output from serial interface showstxload 63/255, rxload 155/255.Is this a high value? Does it means that the bandwidth is not being enough?Thanks

I want to know how to configure leased line to be backed up by ISDN dial-up. The routers at 2 ends are Cisco 1721 & Cisco 2621.Regards,Suraj.

I am trying to connect to sites via ethernet. The only problem that I have is the 2nd router does not have the a third internet port to connect the other router interface. How can I connect the two networks using a switch in between two routers.

Just wondering if it's posible for a 837 router to use a 1Mbps ADSL connection in the UK?As I've been told from another source that it is not possible. I've looked everywhere for a possible answer... Can anyone out there help?!?Richard..

Hello all,Interesting problem here. I have replaced a Dell DSL router with a Cisco 1760 utilizing a WIC1ENET for DSL connection to external modem. Once the change over was complete we started having serious web browsing performance issues. I can g...

I would like to know if anyone has setup 2 2-port T1/E1 Multiflex Voice/WAN Interface Cards into one 2620xm router, I need to setup 40+ sites off of one router and since the 2620 should take 2 wics, 1 for incoming and 1 for out going. I figure using ...

please tell me how to use E1 B channels independently. ? i mean i have 15 offices and 1 E1 line. i want to distribute 2 B channels to each of 15 officies at 128 kbps speed how to configure this on Cisco routers

ISDN issue:2620 router with 4 BRI ports,how to configured it where is support up to 8 1721 router with 1 BRI port individual randomly.

how to troubleshoot serial interface . what are CRC , overruns , throttles underruns etc. Please send me the detail or any link where i can read all this. Available Bandwidth 1536 kilobits/sec 30 second input rate 8000 bits/sec, 11 packets/sec ...

Hi all, I have a pair of C7500 running redundant links (sub interfaces carrying multiple vrf traffics) via ospf and vrrp to ensure high availability and seamless data transfer. The router setup was such that one will be active and the other is standb...

Hi All,As soon as I am telnetting into one of my routers its getting into rommon mode.What could be the problem.Any help will be appreciated.Regards,Saurabh

I have a cisco 1720 router, but everytime i hit copy run start it kept booting up to in image in flash. I erased the image and now all i get is ROMMON> I need two things first how to change the boot sequence in the router so it reads nvram first than...

We are confused by the output of the show ip bpg commands on a 12.0(29)S router and other IOS version routers like a 12.1(22)E1 router. (I have removed most of the ip addresses for security reasons)router1#sh ip bgp xx.xx.xx.xxBGP routing table entry...

HelloI'm trying to configure a 1760 VPN-K9. The fastethernet port receive an IP from the cable modem from my ISP. The problem is that I cannot ping any thing on the internet except the ISP Gateway. Can you help me please.Thank you