04-03-2008 09:49 AM - edited 03-03-2019 09:24 PM
Hi,
Am new to 6509 and 4509 switches,
I have a 6509 and 4509 CAT OS switch which i would like to upgrade to IOS,could any of give me a step by step procedure on how i would go about this.
Thanks a lot.
04-03-2008 10:52 AM
Hi,
6000/6500 CATOS to IOS http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml
Regards,
Dandy
04-09-2008 07:25 PM
As well as the procedure to actually upgrade your system to IOS you will also need to think about converting your current config from CATOS to IOS...
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a0080816fbc.shtml
This is a converter tool which is quite useful, you enter CATOS commands to learn the IOS equivilant, however do double check the results also.
Rate if helps
Urfan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide