Hybrid Environment Meraki MX and Switch Catalyst 3560

Marcos Rogério · ‎05-10-2018

Hi Everyone,

I am working to install a Meraki MX in an existing environment, We use a segregation LAN with a switch cisco catalyst 3560. There is a domain controller and desktops. The diagram is: Internet link <> Meraki mx <> Switch catalyst 3560 <> Lan with AD end desktops. My gateway network is the Catalyt L3.

When I applied the policy from Meraki MX is work well, but if I got uses information from active directory the information not working well.

I would like to know if is there any incompatibility with this environment?

I am going to appreciate this information.

Thank you for your time.

Best Regards.

paul driver · ‎06-04-2018

Hello

I assume you have you successfully tested the AD authentication from the MX and if so what exactly isn't working?

res

Paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul