Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

1131AG Down in WLC even if it is enabled

I have converted 2 standalone 1131AG to LWAPP. On the 4404 controller, both AP's says "Admin status=enabled" and "Oper status=down". How can that be ?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: 1131AG Down in WLC even if it is enabled

Thanks for the ratings. I'm using a number of 1250 AP's with Power Injectors and both Pre-Standard State and Power Injector Selection is not set but the radios are OK.

Oh well, you learn something new everyday!

7 REPLIES
Hall of Fame Super Gold

Re: 1131AG Down in WLC even if it is enabled

What firmware are you running?

Community Member

Re: 1131AG Down in WLC even if it is enabled

c1130-rcvk9w8-tar.123-11JX1.tar

Hall of Fame Super Gold

Re: 1131AG Down in WLC even if it is enabled

Wait a sec ... has the AP JOINED the WLC yet?

You'll get this when the AP is running the RCV IOS/before joining the controller. Once the AP joins the controller (and when you have a valid config), the Admin Status is Enabled and Oper Status will be "REG".

Community Member

Re: 1131AG Down in WLC even if it is enabled

Yes, the AP's have joined the controller. The operational status under "Wireless-All APs" is REG. But still it says that "Operational status" is "down" under "Wireless-Access Points-Radios-802.11b/g/n". It seems though that it is the wireless interface wich is down. Both radio interfaces is enabled under "Admin status"

Community Member

Re: 1131AG Down in WLC even if it is enabled

Found my answer in another thread. It is because of the settings in the WLC for the power injector state !

Posted by: garrsmith - Wireless Engineer, BT iNET - Nov 17, 2008, 11:15am PST

When you use power injectors it's worth setting the power settings on the controller. Set it to power injector state.

I have found that AP's will join the controller but their radios will not power unless you set this.

Hall of Fame Super Gold

Re: 1131AG Down in WLC even if it is enabled

Thanks for the ratings. I'm using a number of 1250 AP's with Power Injectors and both Pre-Standard State and Power Injector Selection is not set but the radios are OK.

Oh well, you learn something new everyday!

Community Member

Re: 1131AG Down in WLC even if it is enabled

Thank you, thank you. I found this post. I had 5 with a state of Down. I saw the power injector setting but didn't do anything with it until I saw your post. They immediately went to up as soon as I clicked the power injector state.

Gary

491
Views
4
Helpful
7
Replies
CreatePlease to create content