Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1240AG dissassociate when ap Authetication is turned on

I have deployed a distributed lwapp wlan solution across 5 locations, which consists of a WISM and 5 3750+wlc a WCS and 180 odd AP,s (most of them 1240AG

WLC's are all running 4.0.179.11 software.

I have Ap authorization enabled on all of them, when i reboot none of the Ap's (with MIC"s) will reassociate to the controllers until i turn of AP authorization.

Any Thoughts?

thanx in advance

2 REPLIES

Re: 1240AG dissassociate when ap Authetication is turned on

Frans,

What type of AAA server are you using? This could be an issue of misconfigurtion. On the AAA server you will need to supply the mac address of the AP as the username and password. Also, you will need to know the format that is being used on the AAA so that you can match it, from the Security tab.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Re: 1240AG dissassociate when ap Authetication is turned on

L.S.

I wasn't aware they had to be authorized against AAA, where i import ssc hashes for older ap's, i just figured the mic's would authorize in sort of the same way, without having to import.

How would i go about configuring this, haven't found anything configurable trough WCS.

165
Views
0
Helpful
2
Replies