Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
339
Views
0
Helpful
1
Replies

1242AG to 1242AG bridge problem

www.itlab.si
Level 1
Level 1

‎04-13-2007 12:38 AM - edited ‎07-03-2021 01:55 PM

Hi,

I have problem setting up a wireless bridge between two 1242AG APs. When i set either of them to any role different than Access Point or Root Bridge i get the interface Software status: Disabled and Hardware: Down. Can anyone tell what is it i am doing wrong ?

Labels:
0 Helpful
1 Reply 1

fmeetz
Level 4
Level 4

‎04-19-2007 08:37 AM

With the 1240 APs you should be able to configure a point to point bridge configuration. Multipoint bridge mode is not supported on this AP. What is the IOS version that you are running on the APs?

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card