Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1242AG to 1242AG bridge problem

Hi,

I have problem setting up a wireless bridge between two 1242AG APs. When i set either of them to any role different than Access Point or Root Bridge i get the interface Software status: Disabled and Hardware: Down. Can anyone tell what is it i am doing wrong ?

1 REPLY
Bronze

Re: 1242AG to 1242AG bridge problem

With the 1240 APs you should be able to configure a point to point bridge configuration. Multipoint bridge mode is not supported on this AP. What is the IOS version that you are running on the APs?

213
Views
0
Helpful
1
Replies
CreatePlease to create content