1310 wireless bridges - gui shows no config, but seen in CLI after update
We have a pair of 'legacy' 1310 bridges that serve as a backup radio link to our primary 1400 bridges. I updated the IOS on both root and remote bridges to 12.3(2)JA4. Subsequently, I see that the G radio interfaces of both bridges are down. Through the GUI I see the log states "No SSID with VLAN configured. Dot11Radio0 not started." Upon further investigation I find that through the GUI none of the running/startup configuration is in place - No VLANs defined, No SSID, etc. However, through the CLI the configuration is all in tact. Anyone see this before?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...