cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
534
Views
0
Helpful
1
Replies

1522 Firmware failure

blakeweston
Level 1
Level 1

Hey, has anyone else experienced this after upgrading the firmware on the Wireless controller? I loaded AIR-WLC4400-K9-4-1-190-5-MESH onto the controller to follow the upgrade path and after it pushed the newer firmware to the AP it no longer boots correctly, the status lights say firmware error, but the image does load without grabbing an IP address and LWAPP association. I am about to attempt a recovery using the files from another AP.

1 Reply 1

smalkeric
Level 6
Level 6

download the code once again from the Cisco web and use that to upgarde the controller. Also power cycle the controller once and try the upgarde the process. I personally ran into a similar issue on a WLC2006 controller and after the power cycle

the upgrade process went through fine.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: