Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1602e standalone AP two SSID's romaing

Hello All,

I have a client that I'm setting up two 1602e standalone AP's. They will be broadcasting the same SSID and on the same VLAN. I was wondering what is going to be the best solution for roaming for the client? I'm relatively new to aironets, but get the basics of them.

-B

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

 Hi,To activate roaming for

 Hi,

To activate roaming for the clients, keep all the settings same on APs

you just need to select different non-overlapping channel on both of the APs.

 

Go below link 

http://rscciew.wordpress.com/2013/11/16/roaming-mobility/

 
4 REPLIES
VIP Purple

Hi,No problem, Everyday is a

Hi,

No problem, Everyday is a new opportinity to learn.

Yes roaming is possible between 2 autonomous APs.

if you are using a PSK, then you just need to do is configure the AP exactly the same way, except  the IP address on the BVI interface.

if you are using 802.1x, then you would want to configure WDS for the key cachhing.

http://www.cisco.com/c/en/us/support/docs/wireless/aironet-1100-series/44720-WDS.html#step1

 

 

How to configure autonomous AP :

http://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-autonomous-ap/

 

Hope it helps.

Regards

Dont forget to rate helpful posts

Bronze

 Hi,To activate roaming for

 Hi,

To activate roaming for the clients, keep all the settings same on APs

you just need to select different non-overlapping channel on both of the APs.

 

Go below link 

http://rscciew.wordpress.com/2013/11/16/roaming-mobility/

 
New Member

So this would mean setting up

So this would mean setting up the same SSID on each AP, but select a different channel for each such as (1,6) and it shouldn't cause an issue? I keep seeing WLC in each article, but this client only has two SAP1602e and no controller in the middle.

 

-B

VIP Purple

Hi,You have only Autonomous

Hi,

You have only Autonomous AP(Without need of WLC).

Just configure both with same config except IP address of BVI interface.(you can select diff channles on both AP)

***IMP*** same ssid and password should be there on both AP.

 

Thats all u need.

How to configure autonomous AP :

http://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-autonomous-ap/

 

Regards

Dont forget to rate helpful posts

 

234
Views
0
Helpful
4
Replies
CreatePlease to create content