Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2 SSIDs, WEP or WPA w/o VLANs?

It must be because it is toooo late at night for me.

I am trying to configure a 1200 with two SSIDs. One will authenticate with WEP, the other with WPA/PSK.

I can set up the WEP SSID OK but when I try to create the second SSID I seem to be told that I have to turn off the WEP key in order to enable the WPA key. I.E. it seems to be AP or radio specific and not SSID specific.

Is it just me?

Thanks, in advance,

Mike

  • Security and Network Management
1 REPLY
New Member

Re: 2 SSIDs, WEP or WPA w/o VLANs?

Mike,

Hope I can save you some time on this. Unless otherwise stated I have tried this myself and actually took it to Cisco TAC. They stated that you have to VLAN out the other authentication protocol you are using. If you are using two SSID's it will require two VLAN's unless that other SSID is a Guest SSID.

122
Views
5
Helpful
1
Replies
This widget could not be displayed.