Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2504 with new-architecture enabled breaks MAC auth for guest access

Hello,

We have (2) 2504 WLC running version 7.6.120. WLC1 is the local controller and WLC2 is an achor controller for guest-access. We need to incorporate a 3850 for use with the WLC2 anchor. The guest access is currently working with Mac-Auth and Mac-Auth-Fail to Web-Auth.

When converged access is enabled on the WLC1 and WLC2, the MAc-Auth no longer works. That is, the previously authenticated user is now redirected to the Web-Auth page. The local controller shows the user as authenticated but the Anchor controller shows the state as WEb-Auth-REQD.

Rolling back using "config mobility new-architecture disable" and rebooting resolves the issue.

Does anyone what changes from the old to the new that would break this mac-auth/web-auth configuration?

Everyone's tags (1)
1 REPLY
VIP Purple

You should reach TAC for

You should reach TAC for these sort of issues. Not many people deploying this CA setup yet & you may not get direct feedback immediately.

HTH

Rasika

 

34
Views
0
Helpful
1
Replies
CreatePlease to create content