Just received our 2710 appliance. Updated it to 5.1.30. Our WCS server is running 5.1.64.
I enabled https. Does that allow https access to the appliance? The default port was 8001. I can't get anything to come up in my borwser. I tried adding :8001 to the end of the url. I was able to run setup from CLI.
THe 5.1 setup wizard allows you to change the WCS password used to talk to the 2710. The wizard doesn't say anything about user name. I used admin on the WCS page for the 2710. WCS seems able to talk to the 2710.
I can view the LA from WCS. Is there a way from the WCS to view/change information that was entered during the CLI setup wizard on the LA. Like the NTP settings. Or do you have to run the wizard again from the LA CLI. Not seeing that information so I assume no.
You can ash or telnet if you allowed it. Or just consolebinto the LA. Don't know the commands off hand, just search for location appliance 2700 configuration guide. This will have the Linux command you can run.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...