When I am setting up the 3355 MSE I have a question about the second ethernet interface. I am not using HA. Can I assign the same IP address to the second port as I do to the first port or does it have to have a seperate address? I noticed in the Prime that when you add the MSE it only asks for one IP address.
So I have a question regarding the port configurtion.
In the autoconfiguration script there is an e0 and e1. However, on the back of the physical box there is a IMM, e1 & e2. I have configured e0 only via the script. But when I ping the default gateway it is reaching out with 220.127.116.11. Even though I have configured it with the correct IP.
I tried to move the cable to the IMM port with no success. I tried E2 with same results.
The startup config is minimal in terms of explaining what each does.
Any idea what physical port e1/2 maps to e0/e1 in the startup configuration and what should be configured and where the cable should be plugged in? No HA setup here. Just a straight IP connection into our network for communication with NCS Prime..
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...