Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

350 Bridge WEP Security

I have a 350 Bridge to Bridge configuration.

Root Bridge & Non-Root Bridge W/O Clients

I want the communication between these (2)

bridges to be secure.

How do I configure WEP?

  • Security and Network Management
1 REPLY
New Member

Re: 350 Bridge WEP Security

Here is where I would suggest starting

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/350brdgs/brscg/index.htm for wireless bridge configurations

to set up wep look under security setup section

best of luck It should be pretty straight forward

PS

make sure you have bridge's set to root without clients and non-root without clients if only using wep in a point to point

97
Views
0
Helpful
1
Replies
This widget could not be displayed.