I have a 350 using ACS for admin authentication. One thing I have not tested yet is how to access the 350 when I have no network connectivity to the RADIUS server. Has anyone tested this? How do I access the AP if the RADIUS server is unavailable.
Re: 350AP, User Authenications, and failed ACS server
I believe that you are able to telnet and browse to the AP without getting authenticated by the Radius server if you are wireless. You would have to setup your AP to only allow you into the device for management so that not everyone could get into it and change the configuration. You would need to do this on the user management page of the AP under the security setup page. If you have no wireless connection due to the radius server, you should be able to hit the AP via a wired PC on the network.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...