Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I hope some lone may be able to help with this
we have a couple of wireless APs connecting to a Cisco 3850 switch. The APs are connected on VLAN 100 which is assigned as the management VLAN for the wireless controller.
Everything worked fine until we tried adding the VLAN into a VRF. Since doing so the APs claim they can't see the controller
We have configured DHCP for the VRF and they get addresses
we have tried manually configuring the APs
we can even ping the IP address of the interface from the AP. But they still claim not to see the controller
We have tried in a lab environment and see the same results
has anybody got any ideas?