Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

5508 1142 H-Reap anyone?

Hello,

Does anyone have a 5508 controller with 1142's setup in H-Reap mode with wpa2/aes/psk authentication?

No matter what configuration i try I cannot get a client connected if the access point is communicating with the controller. As soon as I disable/block the access point from communicating with the controller, the client can connect.

Has anyone else come across this problem? Could anyone else verify the same thing I have?

Thanks,

Dan.

2 REPLIES
Silver

Re: 5508 1142 H-Reap anyone?

An 1142 access point in hybrid-REAP mode sometimes enters stand-alone mode. If the access point is rebooted while in stand-alone mode, the 802.11a radio changes to a different channel than the one configured by the controller after a few minutes.

New Member

Re: 5508 1142 H-Reap anyone?

Very odd problem, but after i restarted the controller everything started working as it should.

Dan.

227
Views
0
Helpful
2
Replies