Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7500 flex dazed and confused message

Uhhuh. NMI received for unknown reason 2d.
Do you have a strange power saving mode enabled?
Dazed and confused, but trying to continue

 

 

I replaced the power supplies and hooked up console but see this message on the box.. TAC didn't want to replace it thinking it was a power issue but it isn't is there any setting or something Im missing on the 7500 WLC ?  this problem started out of the blue

2 REPLIES

NMI ( non maskable interrupt)

NMI ( non maskable interrupt) lets software reboot the device due to hardware failures like fan etc.

New Member

I had to replace the box, it

I had to replace the box, it failed and the tac couldn't diagnose it.  Since it's replacement I've never seen it happen again.  Thanks and just putting this out there should anyone else run into it.

 

G

33
Views
0
Helpful
2
Replies