cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
220
Views
5
Helpful
2
Replies

802.1x on the switch port and Macintosh doesn't work

rschwart
Level 1
Level 1

* When .1x is turned on for a port where a Mac is connected, after the Mac goes to sleep it doesn't get prompted to authenticate until the link on the port is dropped and reinstated?  

The Mac does not continue to have network  access.

 * When the same occurs for a port where a Windows machine is connected, there is an immediate prompt for authentication?

Has anyone had this issue? Does anyone know of a solution.

 

We are using Cisco ISE 1.2.0 and Cisco 3750 switches with version 12.2(55)SE8

2 Replies 2

rschwart
Level 1
Level 1

After 2 TAC cases the solutions comes from Apple. Version 10.10 has resolved issues with 802.1x.

Thanks for the update...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: