Have setup a new test WLAN, using the below on WLC
AAA Radius server configured is the actual ISE server with Advanced defaults > AAA override.
Attached is the client debug from the WLC.
The Authentication error the ISE shows: "5411 No response received during 120 seconds on last EAP message sent to the client"
Is this the client not understanding the EAP authentication method, seems to be happening on Andriod Sony Experia and also IPhones.....in fact every device. You try to connect to the SSID from your device and usually the error is Authentication problem after a few minutes. I'm expecting a username/password where I can enter my Active Directory credentials, which is stated in my ISE policy.
is there a setting on the ISE I need to apply? EAP policy?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...