Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

aaa logged in user disappear after enable mode

Logged In User not showing after going into enable mode on router,

a user shows up in the Logged-In User report on Cisco Secure ACS. With Accounting

the user session is removed from the Logged-In User report when i am going to enable mode.


acs  4.2 Solution Engine-1113

4 REPLIES
Cisco Employee

Re: aaa logged in user disappear after enable mode

Vikram,


Could you please provide me the output of "sh run | in aaa"


Also see if you have this command already there;

aaa accounting exec default start-stop group tacacs+


Regds,
JK

Do rate helpful posts
-

~Jatin Katyal
Community Member

Re: aaa logged in user disappear after enable mode

aaa new-model
aaa authentication login default group tacacs+ local
aaa authentication login consoleport none
aaa authentication enable default group tacacs+ enable
aaa authentication ppp default group tacacs+
aaa authorization config-commands
aaa authorization exec default if-authenticated group tacacs+
aaa authorization commands 0 default group tacacs+ local
aaa authorization commands 1 default group tacacs+ local
aaa authorization commands 15 default group tacacs+ local
aaa authorization network default group tacacs+ local
aaa accounting update newinfo
aaa accounting exec default start-stop group tacacs+
aaa accounting commands 1 default start-stop group tacacs+
aaa accounting commands 15 default start-stop group tacacs+
aaa accounting network default start-stop group tacacs+
aaa accounting connection default start-stop group tacacs+
aaa accounting system default start-stop group tacacs+

Cisco Employee

Re: aaa logged in user disappear after enable mode

Vikram,


All kind of accounting is there? How are you checking logged in user and for what kind of session (VPN)?


Regds

JK


~Jatin Katyal
Community Member

Re: aaa logged in user disappear after enable mode

I have added only switches in ACS

see the attached image there are two users

one is vikram and one is test1

vikram is in enable mode

In acs i am able to see only one logged in user test1, because test1 is not in enable mode.

534
Views
0
Helpful
4
Replies
CreatePlease to create content