I fight with this problem all day and didn't solve it. I would like to use ACS RADIUS to autenticat wirelees clients.
I'v got few ap which got 2 vlans one with without security, second with EAP-LEAP. I configure AP as a client on ACS RADIUS, check LEAP autentication. I configure AP with instruction from cisco.com, and nothing happen.
When I'm trying to connect with my laptop to AP they communicate but client is waiting for ip address from DHCP and didn't get it. All ACL's allow to communicate AP with ACS
dhcp scope configured? ip helper in place? acs group setup with radius attributes 64,65,81? wap configured correctly for ssid, vlan, and subinterfaces to allow for dynamic vlan assignment from acs? it can be a number of things? you say you are seeing the authentication passing right?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...