Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
Start a conversation
235
Views
0
Helpful
0
Replies

Accept client according to there RSSI power in standalone access point

Shehab
Level 1
Level 1

ā€Ž01-21-2014 03:08 AM - edited ā€Ž07-05-2021 12:00 AM

I want to only allow users that are near access point with high RSSI power and force other users with low RSSI power to connect to other nearest AP to them 

I am using standalone AP 1130g

Labels:
0 Helpful
0 Replies 0
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card