02-08-2008 04:03 AM - edited 07-03-2021 03:21 PM
I have some access-points (AIR-LAP-1231G-A-k9) working perfectly with the WLC.
However, when I put the console in the access-point it asks me to enable password default.
I would like to change this password, as I do that?
Solved! Go to Solution.
02-08-2008 05:28 AM
Hi Andre,
When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:
config ap username
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml
Hope this helps!
Rob
02-08-2008 05:28 AM
Hi Andre,
When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:
config ap username
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml
Hope this helps!
Rob
02-08-2008 09:45 AM
Hi,
thanks for help me, but when the LAP is registered to a controller this command not have.
Do know someone a command for hardware test for this LAP???
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: