Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Access-point LWAPP Console Password

I have some access-points (AIR-LAP-1231G-A-k9) working perfectly with the WLC.

However, when I put the console in the access-point it asks me to enable password default.

I would like to change this password, as I do that?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Access-point LWAPP Console Password

Hi Andre,

When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:

config ap username password

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: Access-point LWAPP Console Password

Hi Andre,

When the LAP is registered to a controller, use this controller CLI command to set the AP's username and password:

config ap username password

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml

Hope this helps!

Rob

Re: Access-point LWAPP Console Password

Hi,

thanks for help me, but when the LAP is registered to a controller this command not have.

Do know someone a command for hardware test for this LAP???

thanks

648
Views
0
Helpful
2
Replies
CreatePlease login to create content