I see that auto PAC provisioning is discussed in the ACS 5.1 user guide, but I have serached the GUI, and I just can't find out how to turn auto provisioning on & off.
The user guide talks about the setting being under the global settings for EAP-FAST, which I've found, but there is no mention of auto provisioning. I can see how to manually create a PAC file etc., but no auto provisioning setting.
Auto pac provisioning option is available under access-policies. Please go access-policies >> default network access > click on the tab "Allowed protocols" >> look at the bottom >> Check the option "Allow EAp-fast" and then expand it > here you can configure all the settings on a per access ploicu basis.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...