Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

acs authentication for wireless clients

hi, i am having a little trouble figuring out a problem. I have an aironet 1121 AP and a 2970 switch. I have 4 vlans trunked over to the AP, I am getting to the AP without a problem as it is in guest mode. However I get no authenticaion.

I have configured mac for the clients authentication but I think it is suspect, I am trying to add a mac addresses as users to ACS however it is failing because I can't have the username and password as the same string (the mac address).

I am assuming it is a feature that can be turned off but I am not sure, at any rate a lot of the documentation I have seen talks about doing this but funny enough I have not seen any examples. Could any one point me in the right direction (an example would be nice).

Thanks

kelvin

2 REPLIES
New Member

Re: acs authentication for wireless clients

Go to SYSTEM CONFIGURATION --> LOCAL PASSWORD ADMINISTRATION. There is where you configure the policy.

New Member

Re: acs authentication for wireless clients

thanks but I found it a little while later. It was a long night :-( thanks again

kelvin

132
Views
0
Helpful
2
Replies
CreatePlease login to create content