Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS/ LEAP and 7921G

Hello,

I am having issues with our 7921G's authenticating through our ACS. I am using WCS to control two WiSM controllers. Currently, the SSID is set up to use WPA+WPA2 (AES and CCKM). The AAA settings point to our ACS server and I have LEAP authentication enabled and pointing to a profile. I have the phones configured with the same profile information but in ACS I get and error saying " EAP type not configured". I have gone through the phone and reset all passwords and verified the SSID. Can anyone advise on what to (re)check or where to look?

1 REPLY
Hall of Fame Super Silver

Re: ACS/ LEAP and 7921G

When you get that error on the ACS, it usually means that you didn't configure that EAP type the phones are using on the ACS itself. Try to get a laptop associated and authenticated first, before you try it on the phones.

-Scott
*** Please rate helpful posts ***
199
Views
0
Helpful
1
Replies