Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Add WLC in WCS

Hi,

i can?t add a WLC in my WCS. The WCS can ping the controller, SNMP is configured properly. I got the message "Failed to add device to WCS". The WLC is running Version 4.0.155.0, the WCS is running version 4.0.66.0. Are there any other credentials than snmp which have to be configured ?? Have anybody these versions installed ? Thanks for any suggests.

  • Security and Network Management
2 REPLIES
Hall of Fame Super Silver

Re: Add WLC in WCS

Did you change the default snmp strings in the controller? Make sure that the status is enabled and try setting the ip address and subnet mask to 0.0.0.0. Then try using both the read or the read/write strings. I had that issue today and I just deleted and recreated the strings.

Thanks, Scott *****Help out other by using the rating system and marking answered questions as "Answered"*****
New Member

Re: Add WLC in WCS

Thanks for reply. It works fine. Yesterday I tried this for many hours and now after deleting all strings and recreat it works. Thanks a lot.

283
Views
0
Helpful
2
Replies
This widget could not be displayed.