Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Adding an 1130AG LWAPP to the WLC SHA1 Hash Key

Hi All,

Just wondering if there is an easy way to add a 1130AG to the WLC without needing the debug command to get the SHA1 Hash Key?

Or is there some way in the controllers that I can trust all new access points?

Thanks in advance

2 REPLIES
New Member

Re: Adding an 1130AG LWAPP to the WLC SHA1 Hash Key

Just before people ask.

These AP's were already shipped as LWAPP.

So I did not need to convert them!

Re: Adding an 1130AG LWAPP to the WLC SHA1 Hash Key

If you have a new 1131 that was shipped as an LAP, it should have a MIC installed. There would be no need to input the SHA key, as this is only for a converted AP/LAP that generates an SSC.

Any AP manufactured after 7/2005 should have a MIC installed.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
300
Views
0
Helpful
2
Replies
CreatePlease to create content