I am trying to add the JPEG format map into WCS but unfortunately getting some doubts about area calculation while adding ....
I have map with area mentioned on it but when we add the map into WCS , we need to put length and breadth and automatically we get area which should be matched as per the mentioned map .... but here i do not have details about length or breadth.
do we have any measurement tool inbuilt with WCS where as i can get exact area dimension.
one more thing , roof height .... is it so important that i need to be perticular about ?
standard or default will be 10 feet. ....
could you please let me know the procedure to add map in WCS.... i gone through cisco doc. but in i am not that clear with that doc.
it would be great help to get proper details about this ............
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...