One of my interns was sent to diagnose an access point being out of service. They cycled the POE to the device but it would still not work corectly. They noticed that the LEDs of the device were RED for ethernet and green for radio. The center LED was not illuminated. According the intern (it's his 3rd week) he googled how to reset the device and read that all he needed to do was remove power, hold mode down, then reapply power while holding the mode button down and after 30 seconds it would be reset. So he did just that, and none of the LED's came on. So he power cycled the device and now all three LED's come on RED and the device is a paperweight.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...