...The RADIUS server is up and responding client requests.
...and it looks as though the 1100 is trying to do the right thing, but I don't think I have the sbr method list correctly defined. I don't see any traffic actually go out over the network. Here are the debug messages...
Re: Aironet 1100 authentication open mac-address problems
Thanks for the reply David, but there are no packets going out on the network to the AAA server. Also I think the debug messages I included were incomplete. I just tried to access the network (no setting were changed). here is the debug output. The message...
*21:01:28: AAA/ACCT/NET(00000155): Method list not foundfailed; Cleaning the record up*
Is why I think I am messing up. Again no traffic on the Ethernet side of the 1100 going to the RADIUS server.
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...