Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Aironet 1100 with iPAQ 5450 and LEAP

Hi All,

I have a 5450 iPAQ with built in LEAP support. We use the 1100 Aironets on our WLAN. When I enable LEAP on the iPAQ the device never associates to the AP at all?

I have debugged for "dot11 aaa dot1x all" on the AP but never see any events coming through. It looks as if the device is not associating to the AP at all. The status on the device just sits on "Initialiasing".

I'm running 12.2(8)JA on the 1100. Is there a setting I'm missing to support non-cisco hardware from the AP because my Cisco LAN adapter works fine with LEAP from my laptop.

Has anyone else seen this or got it working?

1 REPLY
Silver

Re: Aironet 1100 with iPAQ 5450 and LEAP

Try resetting all WEP keys on both the AP and the client card. This can help confirm that an error in the key entry was not made, thereby precluding this as a possible source of the inability to complete an association.

134
Views
0
Helpful
1
Replies