I run Aironet 1240AG Access Points. I have 3 buildings with a total of 4 AP. In the building that has 2 AP I got this error message when logging into the AP this morning. "Waring: Filter 701 was configured on interface Dot11Radio0.100 using CLI. It must be cleared via CLI to ensure proper operation of the web interface"
I have never used the CLI on these devices ever, so am very confused by this, nor did I really want to have to use CLI. However suddenly the wireless users cannot connect on this side of the building. What recourse do I have to correct this? I set up the MAC filter using the GUI on all 4 devices so am just at a loss as to what has happened. All 3 other devices are fine including the device on the other side of the building.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...