- Assign same subnet IPs to guest users irrespective of the location they connect to in the network - Issolate guest traffic from rest of the network.
To achieve above task I was recommended 2 Wireless controller, one of them which will act as anchor controller. Data would first be sent to first controller which will analyze the guest user id and password. It will then send the data to anchor controller which will route it to internet.
Is there a possiblty to do this in only 1 wireless controller?
If you put this anchor controller in your DMZ area then you can isolate traffic terminating onto it from rest of your network.
Then you have to have another controller in your normal network to terminate CAPWAP & give corporate wireless. In this setup Guest WLAN you can tunnel back to anchor controller where guest users won't get IP from your normal network, but from anchor controller in DMZ.
So to achieve set requirement you need to have two WLCs. Read this design guide for more detail
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...