Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Anyone captured an RLDP trace

I have not been able to get WiSM controllers on 4.x code to detect a wire-side rogue with open auth (Cisco AP and Apple Airport Express). It did find the open Airport AP once when running 3.x code, but has not since the upgrade.

Has anyone succcessfully captured the Rogue Location Discovery Protocol in action (and has a trace they can share)? Anyone seen an LWAPP AP associate through a Rogue and report it back to the controller?

Thanks,

1 REPLY
Bronze

Re: Anyone captured an RLDP trace

In order for an AP to be detected as a rogue, the following conditions must be present :

-the AP must be 'seen' at least 2 times (through beacons or probes)

-the AP's mac must also be seen on the wired segment

-the AP must be sending beacons or probes

-the AP must be on channel & band that is being monitored.

you may refer to the configuration guide for more information, hope this helps :

http://www.cisco.com/en/US/products/ps6366/products_configuration_guide_chapter09186a00806b0757.html#wp1107407

145
Views
0
Helpful
1
Replies
CreatePlease to create content