Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

AP 1142 will not connect clients to Windows 2008 Radius Server

Our AP 1142 with the attached config is not connecting clients to the radius server located on windows 2008.  If I setup a local radius server on the AP it works fine, but when trying to use the primary server it does not connect.

VLAN 1 is native vlan

VLAN 10 is where data resides

The switch that the AP connects to has the following config:

!

interface FastEthernet0/23

switchport access vlan 10

switchport mode access

spanning-tree portfast

I have enclosed the config for the AP.

David

Everyone's tags (4)
2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Purple

AP 1142 will not connect clients to Windows 2008 Radius Server

Since you are using two vlan traffic, you have to configure AP connected switchport as trunk port. Try this & see

int fa0/23

sw trunk encapsulation dot1q

sw mode trunk

spanning-tree portfast trunk

HTH

Rasika

**** Pls rate all useful responses ****

AP 1142 will not connect clients to Windows 2008 Radius Server

that sounds like a routing issue.  is vlan 1 allowed across all the links up/down stream?

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
6 REPLIES
VIP Purple

AP 1142 will not connect clients to Windows 2008 Radius Server

Since you are using two vlan traffic, you have to configure AP connected switchport as trunk port. Try this & see

int fa0/23

sw trunk encapsulation dot1q

sw mode trunk

spanning-tree portfast trunk

HTH

Rasika

**** Pls rate all useful responses ****

Re: AP 1142 will not connect clients to Windows 2008 Radius Serv

The switch is a 2960s and won't let me do dot1q encapsulation. Any thoughts?

VIP Purple

Re: AP 1142 will not connect clients to Windows 2008 Radius Serv

in 2960 trunk ports by default it is supporting dot1q & you do not require that configuration line. Other two sufficient

Rasika

AP 1142 will not connect clients to Windows 2008 Radius Server

With the settings I can only access the AP directly from the switch and no where else on the network can I see it.  When pinging IP from desktop machines they time out.

AP 1142 will not connect clients to Windows 2008 Radius Server

that sounds like a routing issue.  is vlan 1 allowed across all the links up/down stream?

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

Re: AP 1142 will not connect clients to Windows 2008 Radius Serv

Got the config to work on the switch but now get the same radius issues.  I have enclosed the radius debuig.

350
Views
0
Helpful
6
Replies
CreatePlease login to create content