Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP 1231G-A-K9 won't accept WLSE configuration jobs

The AP (AP1231G-A-K9)has an internal G card and an A card was inserted. The AP was upgraded to firmware version 12.3.7.JA,

The first configuration job was successful. Whenever another configuration job is applied to the AP using the WLSE, The Job status says "failed" and the job state is "complete."

I reseted the AP back to the default factory settings using the web interface and still no success. I also did a hard reset on the AP and still no luck.

The only way I get the AP to accept a configuration job is to go through telnet. However I need to apply a scheduled job to the AP and need to use the WLSE.

Please help

1 REPLY
Blue

Re: AP 1231G-A-K9 won't accept WLSE configuration jobs

What is the WLSE version?. Are you using telnet or ssh for the config job?. Is the AP in question discovered and in the Managed Inventory list?

136
Views
0
Helpful
1
Replies
CreatePlease login to create content