Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AP/Client SSO trapping

Hello Guys,

I have successfully configured AP/Client SSO on our 2 WISM2 modules (7.6.130). SSO is working fine when powering down the primary unit or doing a redundancy force-switchover.

However, not any SNMP trap are sent by the units when a failure and switchover happens - we don't see any alarm concerning SSO in our Prime infrastructure 2.1 nor in the syslog sent by the WLC.

Is there any way to be informed (SNMP/Syslog) when a WISM2 of the HA is failling ?

 

Thanks for you answer :)

17
Views
0
Helpful
0
Replies