Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AP Group steps by CLI

Hi,

I know how to do this by WCS or Web to WLC but not by CLI.

Config Guide doesn't seem to have it.

How do I use CLI to associate the

- AP Group (which I already created)

- the SSID

- the interface

Thanks, MH

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: AP Group steps by CLI

Hi Mark,

Here are the CLI steps;

Note: Issue this command in order to enable the AP Group VLANs feature from the CLI:

config location enable/disable

Note: Issue this command in order to define the location string (AP group name) using the CLI:

config location add

Note: Issue this command in order to map the interface to the AP groups through the CLI:

config location interface-mapping add

Starting from Wireless LAN Controller Version 4.1.181.0, the commands to configure AP groups with the CLI have changed. In Version 4.1.181.0, these are the commands used to configure a new AP group with the CLI:

In order to enable an AP group, use this:

config wlan apgroup add

In order to delete an existing group, use this:

config wlan apgroup delete

In order to add a description to the AP group, use this:

config wlan apgroup description

In order to create a new AP group/WLAN/interface mapping, use this:

config wlan apgroup interface-mapping add

Note: Issue this command from the controller CLI in order to assign an AP group to an LAP:

config ap group-name

For WLCs that run version 4.1.181.0 or later, use this command to verify the AP Group VLAN configuration.

show wlan apgroups

From this good doc;

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml

Hope this helps!

Rob

1 REPLY
Hall of Fame Super Red

Re: AP Group steps by CLI

Hi Mark,

Here are the CLI steps;

Note: Issue this command in order to enable the AP Group VLANs feature from the CLI:

config location enable/disable

Note: Issue this command in order to define the location string (AP group name) using the CLI:

config location add

Note: Issue this command in order to map the interface to the AP groups through the CLI:

config location interface-mapping add

Starting from Wireless LAN Controller Version 4.1.181.0, the commands to configure AP groups with the CLI have changed. In Version 4.1.181.0, these are the commands used to configure a new AP group with the CLI:

In order to enable an AP group, use this:

config wlan apgroup add

In order to delete an existing group, use this:

config wlan apgroup delete

In order to add a description to the AP group, use this:

config wlan apgroup description

In order to create a new AP group/WLAN/interface mapping, use this:

config wlan apgroup interface-mapping add

Note: Issue this command from the controller CLI in order to assign an AP group to an LAP:

config ap group-name

For WLCs that run version 4.1.181.0 or later, use this command to verify the AP Group VLAN configuration.

show wlan apgroups

From this good doc;

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml

Hope this helps!

Rob

448
Views
0
Helpful
1
Replies
CreatePlease to create content