Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

AP's 1240 Change to Red Color in the WLSE

Hi

I work with the WLSE and I connect more APs 1240 in my network, but when I try to add these devices appear in red color or in other cases in yellow color. I check the IOS version of that Devices and does not appear to be that.

3 REPLIES
Hall of Fame Super Silver

Re: AP's 1240 Change to Red Color in the WLSE

Maybe the ap is unreachable via snmp.

-Scott
*** Please rate helpful posts ***

Re: AP's 1240 Change to Red Color in the WLSE

Or perhaps the individual radios are disabled ?

If the APs are new ... the radios are disabled by default.

New Member

Re: AP's 1240 Change to Red Color in the WLSE

No Msr, Thanks for your opinion, but That AP's was installed and worked in the network. I think That problem it's because the Ap's has interference. When I instal other Ios Version, I saw the Ap's change to yellow color and before that change I saw The Ap's int red color.

Waht do you Think??

145
Views
0
Helpful
3
Replies
CreatePlease to create content