AP's / Wireless Controllers and WCS Network Design Diagrams?
Anyone have any good network design diagrams / maps involving at least two wireless controllers in two seperate locations but managed by one WCS. Hoping to take a look at what others have done, the layout and IP addressing / subnetting and so on to get ideas on the best way for me to migrate our existing wireless network from standalone AP's to LWAPP using two controllers at two different locations connecting back to main WCS.
I know we will be using L3 LWAPP since we need to and Cisco recommends it from what I have read.
I have about 20 AP's connecting to each controller, both controllers are in seperate physical locations. One controller is in the same location as the WCS but that does not seem to matter a whole lot.
Anyway, if anyone has some diagrams either public ones you can point me to or internal ones with anything private stripped out I would greatly appreciate a chance to review them.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...